Adding a Firewall Rule

Scenarios

Add an inbound or outbound rule based on your network security requirements.

Procedure

  1. Log in to the management console.

  1. Click image1 in the upper left corner and select the desired region and project.

  2. On the console homepage, under , click Virtual Private Cloud.

  3. In the navigation pane on the left, choose Access Control > Firewalls.

  4. Locate the target firewall and click its name to switch to the page showing details of that particular firewall.

  5. On the Inbound Rules or Outbound Rules tab, click Add Rule to add an inbound or outbound rule.

    • Click + to add more rules.

    • Locate the row that contains the firewall rule and click Replicate in the Operation column to replicate an existing rule.

    Table 1 Parameter descriptions

    Parameter

    Description

    Example Value

    Priority

    Priority of a firewall rule. A smaller priority value represents a higher priority. Each network ACL includes a default rule whose priority value is an asterisk (*). Default rules have the lowest priority.

    3

    Status

    Status of a firewall. When you add a rule to it, its default status is Enabled.

    Enabled

    Type

    The firewall type. This parameter is mandatory. You can select a value from the drop-down list. Currently, only IPv4 and IPv6 are supported.

    IPv4

    Action

    The action in the firewall. This parameter is mandatory. You can select a value from the drop-down list. Currently, the value can be Allow or Deny.

    Allow

    Protocol

    The protocol supported by the firewall. This parameter is mandatory. You can select a protocol from the drop-down list.

    You can select TCP, UDP, ICMP, or All.

    TCP

    Source

    The source from which the traffic is allowed. The source can be an IP address or IP address range.

    • IP address:

      • Single IP address: 192.168.10.10/32

      • All IP addresses: 0.0.0.0/0

      • IP address range: 192.168.1.0/24

    • Security group: sg-A

    0.0.0.0/0

    Source Port Range

    The source port number or port number range. The value ranges from 1 to 65535. For a port number range, enter two port numbers connected by a hyphen (-). For example, 1-100.

    22, or 22-30

    Destination

    The destination to which the traffic is allowed. The destination can be an IP address or IP address range.

    • IP address:

      • Single IP address: 192.168.10.10/32

      • All IP addresses: 0.0.0.0/0

      • IP address range: 192.168.1.0/24

    • Security group: sg-A

    0.0.0.0/0

    Destination Port Range

    The destination port number or port number range. The value ranges from 1 to 65535. For a port number range, enter two port numbers connected by a hyphen (-). For example, 1-100.

    You must specify this parameter if TCP or UDP is selected for Protocol.

    22, or 22-30

    Description

    Supplementary information about the firewall rule. This parameter is optional.

    The description can contain a maximum of 255 characters and cannot contain angle brackets (< or >).

    N/A

  6. Click OK.